Jiangsu QiSheng Cable Co., Ltd.
1 Tools 1.1 Rubber gloves and masks 1.2 High level bath of glass 1.3 Hand pressure roller 1.4 Alcohol and dust clotes 2 Instructions 2.1 Put on rubber gloves, firstly use the dust cloth and bath of glass to clean off the dirts on the glass, and then clean the glass surface along one direction to make sure that there is no other residual, and impurities or raab articles. 2.2 Put the smart film on a clean table, ensure the film with glue upward , then use alcohol and lint-free cloth to clean off the dirts to make sure there is no no other residual dust or impurities. 2.3 Under dust-free environment, pls tear off 2-3cm protective film on the top of the smart film, and then put the smart film on the glass, it should be align the bottom up, pls paste the 2-3cm smart film with the glass closely when both ends. 2.4 Use electric iron to weld the wire on copper terminals 2.5 Plastic strip protective electrodes, hide the wires under plastic trunking 2.6 Use tape to tear off another layer of protection film. 2.7 Connect the circuit and debug by an electrician. 2.8 After debug, inject neutral glue to the edge of the smart film-about 5mm strip, it only can be Power ON and operated after the glass glue dry completely ( around 3 days). 2.9 Finally, Use 3M adhesive for sealing. 3 Precautions 3.1 During installation, except clean the glass, it is forbidden t use water under any circumstance. 3.2 When you order smart film, the size should be smaller ( 2-3 mm less than the glass), it can avoid the direct contact between the edge of smart film and metal frame of the glass. 3.3 If for long term use, it can inject neutral glass glue at the edge of smart film. 3.4 Suggest wear masks and gloves while operation, and under dust-free environment (Whatsapp) E: W:
Copyright © 2019 Jiangsu QiSheng Cable Co., Ltd. All rights reserved.