Jiangsu QiSheng Cable Co., Ltd.
Today we are making a Ring Light (Mini) for your mini studio DIY.——————————Things you needed———————– - Round plastic ring - 3 mm White LED – 8 Nos. - 150 ohm resistor – 8 Nos. - 4.3V, 70 mA DC Power supply - Solid copper wire with Alligator clip - 2.5 sq mm copper lug - Heat Shrink tube - Hook up wires & screw - Super glue——————————- Tools Needed —————————– - Dremel 4000 / Drill Machine - Soldering Iron - Lighter - Screwdriver set ————————————Steps————————————— - 8 Nos. hole in plastic ring - fix 8 Nos. 3 mm LED in each hole using Super glue - Cut small leg of LED which is negative point - Solder all negative terminal to-gather make negative input terminal - Then cut positive terminal of LED slight bigger then negative terminal - Solder 150 ohm resistor to positive terminal of LED - Then Solder all resistors terminal to-gather and make positive input terminal - Then solder 4.3V power supply with LED terminals - Then cover it with heat shrink tube - Connect Solid copper wire to ring light and test it.Our Mini LED ring light id ready…
Copyright © 2019 Jiangsu QiSheng Cable Co., Ltd. All rights reserved.